To enter service mode press the "MENU" and
"IMAGE" buttons on the projector simultaneously and hold for 2
seconds. As shown in a figure, a service mode display appears on a screen.
Adjustment
Adjust service data using the following control buttons.
"POINT UP" >> An item number increases.
"POINT DOWN" >> An item number decreases.
"POINT RIGHT"
>> An adjustment value
increases.
"VOLUME+"
"POINT LEFT" >> An adjustment value decreases.
"VOLUME - "
Press the "POWER on/off" button only once on the
projector or remote control unit to quit the service mode.
SERVICE MODE ADJUSTMENT MENU
Caution : Other
adjustment items are not related to service and a maintenance. Don't press the
VOLUME (+) and (-) buttons at the time of those adjustment items. Otherwise it
may cause loss of product safety.
Fan driving voltage adjustment
- Enter the Service mode.
- Set the item no. To [50] by pressing the Point up or down button. Set the data value to [1] by pressing the Volume + or - button.
- Set the item no. To [67]. Set the data value to [1].
- Adjust the voltages of TP66A to 8.4 ± 0.1 V-DC by the VR5601.
- Set the item no. To [50]. Set the data value to [0].
- Set the item no. To [67]. Set the data value to [1]
The fuse is located on the ass'y-power. When either the LAMP
indicator or the READY indicator is not illuminated, fuse may be opened. Check
the fuse as following steps.
Remove the ass'y-power.
Remove the fuse from fuse holder.
Check the resistance of fuse by using the tester. To install the fuse, take reversed step in
the above.
OVERHEATING PROTECTION (The temperature monitor system)
The temperature monitor system is provided to prevent damage
of component parts inside the projector from overheat. Two protection systems
are provided. Each system operating as follows.
Temperature monitor -1 :
When this function operates, warning-temperature-indicator
flashes. And cooling fan continues operating until it becomes a normal
temperature. If it continue to flush and flash does not stopped, disconnect the
AC cord and investigate the cause of overheating.
Temperature monitor -2 : (thermal switch SW902)
This function (thermal switch SW902) will not operate, while
the temperature monitor -1 is operating normally. If it has operated, it needs
to be reset manually. Disconnect the AC cord first and investigate the cause of
overheating. After servicing, reset the
thermal switch (SW902) as shown in the figure.
LAMP REPLACEMENT
When the life of Projection Lamp of this projector draws to
an end, LAMP REPLACEMENT indicator lights yellow. When a projected image becomes dark or the color of an image
becomes unnatural, replacement of Projection Lamp is required.
- Turn off the projector and disconnect AC plug. Allow the projector to cool for at least 45 minutes.
- Remove a screw with a screwdriver to remove Lamp Cover.
- Remove 2 screws with a screwdriver and pull out Lamp Assembly by grasping Handle.
- Replace Lamp Assembly with a new one and tighten 2 screws back. Make sure that Lamp Assembly is set properly. Replace Lamp Cover and tighten a screw.
- Connect AC Power Cord to the projector and turn it on.
- Reset Lamp Replace Counter (refer to the section “Lamp Replace Counter” below).
LAMP REPLACE COUNTER
Be sure to reset Lamp Replace Counter when Lamp Assembly is
replaced. When Lamp Replace Counter is reset, LAMP REPLACE Indicator stops
lighting.
- Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button(s) to move a red frame pointer to SETTING Menu icon.
- Press POINT DOWN button to move a red frame pointer to “Lamp counter reset” and then press SET button. The message "Lamp replace counter reset?" is displayed. Move the pointer to [Yes] and then press SET button.
- Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter.
