FORD MONDEO - HOW TO CHECK ANTI-THEFT ALARM SYSTEM
ANTI-THEFT ALARM SYSTEM
- The system includes a start inhibitor circuit, which makes
it impossible to start the engine with the system armed.
- The movement sensors consist of two ultrasonic units,
located in the “B” pillars, incorporating transmitters and receivers (see illustrations).
The receivers check that the echo frequency matches the original frequency. If
there is any significant difference, the system triggers the alarm.
- The system module is located on a bracket beneath the
right-hand side of the fascia. The set and reset switches are located in a housing
by the lock barrel holder in the doors, tailgate or boot lid.
- To allow temporary opening of the tailgate or boot lid, an
inhibit switch is fitted to the lock barrel. This suppresses the alarm system
until the tailgate or boot lid is closed again.
- Where remote central locking is fitted, an infra-red
receiver is located on the exterior door handle (see illustration). Note that excessive
heat can destroy this receiver; therefore, it should be covered with aluminum tape
if (for instance) a paint-drying heat process is to be used.
- The alarm system is fitted with its own horn. On Hatchback
and Saloon models, it is located on the left-hand side of the luggage compartment;
on Estate models, it is located on the right-hand side of the luggage compartment
(see illustration).
- The alarm system incorporates a self-test function, which
can be activated by operating the bonnet switch or one of the lock position switches
eight times within 10 seconds. During the check, the horn or buzzer issues acoustic
signals, which should occur every time a door, bonnet or tailgate is opened. If
the doors are double-locked, the signal will occur when something is moved
within the passenger compartment. A more comprehensive test can be made using
the Ford FDS 2000 diagnostic tester.
- The door lock switches associated with the alarm system are
located behind the door trim panels (see illustration).