Saturday, June 15, 2013

PHILIPS MCM277/05/12/98 - MICROSYSTEM - MAIN BOARD - MCU BOARD - SCHEMATIC DIAGRAM - Common Faults & Checks


MAIN BOARD SCHEMATIC - TYPE -1
Click on schematics to Magnify
MAIN BOARD SCHEMATIC - TYPE - 2
CD & MCU BOARD SCHEMATIC
MCU PORTION

COMMON FAULTS
PROBLEM
SOLUTION

“NO DISC” is displayed
Insert a disc. Wait until the moisture condensation at the lens has cleared.
Replace or clean the disc, see “Maintenance”.
Use a finalised CD-RW or a correct MP3/WMA -CD format disc

Some files on the USB device are not
displayed
Check if the number of folders exceeds 99 or
the number of titles exceeds 999

Radio reception is poor
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
Increase the distance between the Micro HiFi
System and your TV or VCR

The system does not react when buttons
are pressed
Remove and reconnect the AC power plug and switch on the system again

Sound cannot be heard or is of poor quality
Adjust the volume.  Disconnect the headphones.
Check that the speakers are connected correctly.
Check if the stripped speaker wire is clamped.
Make sure the MP3-CD was recorded within
32~256 kbps bit rate with sampling frequencies at 48 kHz, 44.1 kHz or 32 kHz

The left and right sound outputs are reversed
Check the speaker connections and location

The remote control does not function
properly.
elect the source (CD or TUNER, for example)
before pressing the function button (>|| , |< , >| )
Reduce the distance between the remote
control and the system. Insert the battery with its polarities (+/– signs) aligned as indicated.
Replace the battery.
Point the remote control directly toward
IR sensor on the front of the system.

he timer is not working.
Check the set is switched off.  Set the clock correctly.
Press TIMER to switch on the timer

The Clock/Timer setting is erased
Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer