SERVICE INSTRUCTIONS
General Adjustment : In general, a color TV can provide
ideal visual quality by adjusting the basic settings such as the vertical size,
horizontal size, focus, etc.
Display a black and white picture on the screen to
check if the picture is clearly displayed.
If there are some 'spotted' points on the screen when displaying a black
and white picture, degauss the screen using the degauss coil. If the spotted
points remain, re-adjust the purity and the convergence. This completes the
basic performance examination.
These adjustments and the check list are only applied to
S62A chassis-applied models.
Only use 230V for the measurement set. It is recommended
using an insulation transformer when supplying power to the set so as to
prevent shock to the set or to yourself. These adjustment specifications have been created on
the basis of the domestic S62A chassis-applied remote control model. Some of
the contents may be changed subject to the sales location and the product
specifications.
When replacing the System Board : Since the software is loaded to the flash memory of the system
board, check the version of the software after replacing the board.
To check the version of the software, Enter service
mode press the key on the remote control according to the following
(in stand-by status) Info => Menu => Mute => Power
=> ON
The software information will then be displayed below the
OSD menu.
The notation of the software information :
For example, T_OZPEU_1000 refers to "OZ BASIC MODEL
Europe. ver.1000".
Since the settings including the Channel information,
Deflection, etc. are saved to the nvRAM,
reconfigure these settings when replacing the System Board.
When replacing the Deflection Board : Tilt adjustment, focus
adjustment, screen voltage setting and W/B adjustment are all required.
When replacing the Power Board : No adjustments required.
When replacing the CRT Ass'y : No adjustments required.
When replacing the front panel master power switch : No
adjustments required.
When replacing the Side AV : No adjustments required.
When replacing the control switch : No adjustments required.
SERVICE MODE ACCESS
To enter Service Mode, press the keys on the remote control
according to the following sequence. (in Stand-by status)
Info èMenu èMute èPower On
When failing to enter Service Mode, repeat the
procedure above.
INITIAL SCREEN OF SERVICE MODE
- Move the cursor to select an item by using [▲/▼] button on the remote control.
- Adjust the selected configuration value by using [Left / Right] button on the remote control.
FACTORY DATA
Deflection [PAL]
Deflection [NTSC]
ADJUSTMENTS