Contn:
[2]
INSTALL FLASH DOWNLOAD IN PC
Open up EPROM WRITER.alz which is a compressed file with ALZip, and extract Port95nt.exe file to setup.
For setting up, keep clicking on 'Next', until finish appears.
Run 'Flash Downlaod'
After extracting compressed file, Flashdown4023.exe icon is created. By running the file, the following picture pot ups. If this picture doesn't display by running this .exe file, recheck the installation of 'Port95nt.exe' file and install file if it does not installed.
Flash download program: By clicking model number, the number of saved model displays from 1 to a (10 at maximum). Specify model number.
Open file after specifying model number. Select ROM file in [*.bin] form to download.
Running process details:
Erase = Down > Erase existing data in ROM and it runs automatically again to download. [Always check ROM version when downloading]
Check the version is the same as the date on LCD window when the first power of EPROM Writer is applied. The green LED of EPROM Writer will be ON, when normal operation. [Red LED is On if error]. If communication is difficult by errors in operation, remove 25P print cable and press down INITIALIZE key to initialize the print port and try again.
- To change Mode, press down Model Up, Down simultaneously and turn Power On when the first Power is On.
- [Ser => Epp, Epp => Ser:Epp (General Mode), Ser(Serial Communication Mode) [phone jack])
- Always check the Mode when Power is On.
- When program is not downloaded, the program version doesn't display at the first Power On.
- Be sure to check the version of program before downloading. It it did not checked, the download could be duplicated.
- Center LED is lighted when power is On.
- By pressing function key, green LED on upper right is ON and starts to operate.
- When it is downloading green LED is flickering.
- When error occurs during operation red LED is On.
- Should press down key more than 0.3 seconds to operate [to prevent wrong operation]
No comments:
Post a Comment