EPSON - STYLUS PHOTO 1200 _ ADJUSTMENT PROGRAM

Activatioin of Program

• Turn off both printer and host computer, and connect them with parallel interface cable.
• Turn on the printer and host computer.
•  Make a folder in the host computer and save the file of adjustment program in that folder. Or, insert the disk of the adjustment program into the disk drive.

 Run the program on the DOS Prompt of the Windows. The following screen will appear.

 Select “Stylus Photo 1200” by using ‘Up/Dn’ key and press “Enter” key.  Then, the screen for destination will appear.

Select “World” and press “Enter” key. The following screen will appear.

Select “Perform (Boot this PROGRAM).

 Since the basic component of EPSON Stylus Photo 1200 is same as that of EPSON Stylus Photo750, refer to the Service Manual of EPSON Stylus Photo 750 for maintenance.