MARANTZ - CD 6000 _ CD 6000F _ CD 6000OSE _ SERVICE MODE _ and ERROR CODES

TO ENTER SERVICE MODE

• Turn the power on while pressing [PLAY]+[OPEN/ CLOSE] buttons together.
• The display shows “model number”, “microprocessor version” and “mode”.

===================

CD 60 : 1 0 P 0 0

===================

CD 60 > Model Number.

1 0 P > Microprocessor version.

0 0  > Mode Number.

• Condition: [FOCUS OFF], [SPINDLE OFF], [RADIAL OFF], [MUTE ON].
• While pressing [NEXT ] ( >>| )the sledge moves out side.
• And, release from this button. The sledge return to neutral position.

Press [NEXT >>| ] button, the function will change to “Mode 1”.

Mode 1[display "P 01"]

• Condition: [FOCUS ON], [SPINDLE OFF], [RADIAL OFF], [MUTE ON].
• Press [Next >>| ] button, the function will change to “Mode 2”.
• Press {PRE |<<} button, the function will change to “Mode 0”.

Mode 2 (display “P 02”)

• Condition: [FOCUS ON], [SPINDLE ON], [RADIAL OFF], [MUTE ON]
• Press {Next >>| } button, the function will change to “Mode 3”
• Press { Pre |<<} button, the function will change to “Mode 1”

Mode 3 (display “P 03”)

• Condition: [FOCUS ON], [SPINDLE ON], [RADIAL ON], [MUTE OFF].
• Press {Pre |<< } button, the function will change to “Mode 2”.
• Note:  The following button operations are available at the Service Mode.

1. While pressing [STOP] button, FL display shows all segments.
2. Press [PAUSE] button. FL display shows each segments one by one automatically. (Segments test mode) And, press [PAUSE] button again, this mode will be stopped.
3. The same as Normal operation is performed by pressing [PLAY] button. (Except segments test mode.).   However if some default is detected, display shows an error code. (For example: “Err 10”) Refer to the “Table 1 ERROR CODE”.

ERROR CODES

Error code	Error
Err 2	Focus error
Err 7	Sub Code error
Err 8	T.O.C error
Err 9	Decoder error
Err 10	Radial error
Error 11, 12	Sledge error
Err 13	Spindle error
Err 16 ~ 20	Search error
Err 30	Door error
Err 31	Tray error
Err 32 ~ 47	Button input error