- PC (with S/W : EDID Data write & Read)
- EDID DOWNLOAD JIG
- HDMI Cable, D-Sub cable.
CONNECTION PROCEDURE
TO DOWNLOAD
- Configure the download environment as shown at the adjustment wiring diagram and turn on the PC.
- Execute the DDC program. (EDID Data Write & Read).
- Go to Model -> Open, and select the EDID data of the desired model.
- Check the item to download from the <Test> item. {HDMI & RGB: Check Digital & Analog} / {(Only)HDMI: Check Digital only}.
- Press ESC(Cancel Mode) -> F8(Auto Mode). (Set Auto Detecting).
USB S/W DOWNLOAD [OPTION]
- After turning on the set, make sure that the display screen is turned on.
- When the USB Memory Stick with the upgrade file applied is inserted into the USB jack on the main board, the following screen (example) is displayed after several seconds.
- Check the current version at [Current TV Software Version Information], check the S/W version to upgrade at [Software file list in USB Memory], and press the Enter button of the TV remote controller.
- Downloading is proceeded as shown at the below screen, and when it is ended, turning on/off is automatically done. (When the automatic proceeding is not smoothly done, manually perform the power On/Off).
- When downloading is ended, remove the USB Memory Stick from the USB jack.
- Press the IN-START button of the remote controller to check the upgraded S/W version.
TO ENTER FACTORY MODE [SERVICE MODE]
- Press the In-Start key of the R/C and press the red oval OP1(PIP CH-) key to enter into the Factory Option menu.
- Select 1.USA, 2.CANADA or 3.MEXICO from the country select according to the destination. At this time, use the volume +/- key to adjust.
