Repaired SSB Reset Procedure
A very important issue towards a
repaired SSB from a Service repair shop (SSB repair on component level) implies
the reset of the NVM on the SSB. A
repaired SSB in Service should get the service Set type “00PF0000000000” and
Production code “00000000000000”. Also
the virgin bit is to be set. To set all this, you can use the ComPair tool or
use the “NVM editor” and “Dealer options” items in SAM (do not forget to
“store”).
After a repaired SSB has been mounted
in the set (repair on board level), the type number (CTN) and production code
of the TV has to be set according to the type plate of the set. For this, you
can use the NVM editor in SAM. The loading of the CTN and production code can
also be done via ComPair (Model number programming). In case of a display replacement, reset the “Operation hours display”
to “0”, or to the operation hours of the replacement display.
No comments:
Post a Comment