Using the Customer Remote
- Turn the power off and set to stand-by mode.
- Press the remote buttons in this order; MUTE-1-8-2-POWER ON to turn the set on.
- The set turns on and enters service mode. This may take approximately 20 seconds.
- Press the Power button to exit and store data in memory.
- If you fail to enter service mode, repeat steps 1 and 2 above.
INITIAL SERVICE MODE DISPLAY
A-TYPE
B-TYPE
How to enter the hidden factory mode.
(a). into the factory mode
(b). scroll down and highlight advanced
©. key input : 0 + 0 + 0 + 0
** hidden menu : Picture
But you can't modify the menu (2010 models).
Buttons operations within Service Mode.
Direction Keys ▲/▼ => Item Selection by Moving the Cursor.
Direction Keys◄/► => Data Increase / Decrease for the
Selected Item.
Source => Cycles through the active input source that are
connected to the unit.
DETAIL FACTORY OPTION
If you replace the main board with new one, please change
the factory option as well.
The options you must change are “Type”
W/B ADJUSTMENT
- You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
- Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS, Component 1 and HDMI 1 modes.
- The optimal values for each mode are configured by default.
- It varies with Panel’s size and Specification.
Equipment : CS-210
- Pattern: MIK K-7256 #92 “Flat W/B Pattern” as standard
- Use other equipment only after comparing the result with that of the Master equipment.
- Set Aging time : 60min.
Calibration and Manual setting for WB adjustment.
- HDMI : Calibration at #24 Chessboard Pattern è Manual adjustment #92 pattern (720p)
- COMP: Calibration at #24 Chessboard Pattern è Manual adjustment at #92 pattern (720p)
- CVBS: Calibration at #24 Chessboard Pattern è Manual adjustment at #92 pattern (NTSC)
If finishing in HDMI mode, adjustment coordinate is almost
same in AV/COMP mode White Balance Manual Adjustment.
CONNECTOR CABLES
Click on images to Enlarge
