SHARP LC32CT2E - LC40F22E - LC40CT2E - LC42CT2E - LC32D12E - WILL NOT START-UP WHEN SET HAS BEEN IN STANDBY

SET WON'T START-UP FROM STANDBY

• The resistors R817,R818,R819 on the power supply PWB are out of tolerance.
• Replace all 3 surface mounted resistors using Figure  for location and ensure the set has the latest operating software installed.

[R817, R818, R819.] [SMD 1/3W HV 620K] [ PART No: SMD 1/3W HV 620K]

• To check the version of the operating software, in the service menu press the following buttons in sequence. 4,7,2,5. And ensure the software level displayed is greater than V0.3.0.

Instructions for software update.

1. Download from the technical web site the latest software for the model.
2. Unzip the file.
3. Put this file into the root directory of your USB memory stick.
4. Turn On the television to be updated and wait until the picture appears.
5. Insert the USB stick into the USB socket.
6. Follow the on-screen instructions that appear.
7. When completed switch off the set and remove the USB stick.

MAINS AC FUSE LOCATION

The wires in the mains lead are colored in accordance with the following code :

IMPORTANT

• As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings identifying the terminals in your plug, proceed as follows:
• The wire, which is, colored green and yellow must be connected to the terminal which is marked with the letter E, or by the earth symbol, or colored green or green and yellow.
• The wire, which is, colored blue or black must be connected to the terminal which is marked with the letter N or colored Black.
• The wire, which is, colored brown or red must be connected to the terminal which is marked with the letter L or colored Red.
• For continued protection against risk of fire, replace only with same type and rating of fuse (ASTA approved 5A 250VAC fuse).