- Refer to the DEVICE CODE LIST, look up the 4-digit Device Code, which corresponds to the brands of your A/V equipment. If there are more than one Device Code listed under your brand, try from the first code.
- Press a desired Device Mode Key (e.g. ).
- Hold down “ P+” and “ VOL–”on the URC together simultaneously for 2 seconds until the indicator lights up.
- Use the number keys to enter your 4-digit Device Code, the indicator should go out immediately.
- Turn on your device (e.g. TV), try the function keys on the URC. If your device (e.g. TV) responds to your invoked function correctly, you have entered the right Device Code. Otherwise, repeat the above setup instructions with the rest available Device Codes until your device (e.g. TV) responds to your evoked function, and most keys work correctly.
- Simply repeat the above procedures to enter the Device Codes for your VCR, SAT, DVD or CTV. (Remember to press a correct Device Mode Key in step 2 above).
Note : DVD, CTV and
other Device Codes can be entered into any device modes except “TV” & “VCR”
modes. Just simply press the device mode key and enter your 4-digit device code for DVD, CTV and other
devices. If the indicator flashes twice
in step 4, a wrong Device Code has been entered. You are required to repeat
step 2 to 4 again.
Suggestion : If you
cannot find a correct Device Code for your equipment, do a code search method.
CODE SEARCH METHOD
- Turn on your device manually (e.g. TV).
- Press a desired Device Mode Key (e.g. ).
- Hold down “ P+” and “ VOL–” on the URC together simultaneously for 2 seconds until the indicator lights up.
- Enter a corresponding Magic Search Code from following table. The indicator should go out immediately.
- Press the same desired device mode key again as in step 2 above. (e.g. )
- Hold down “ P+” & “ VOL–” together simultaneously for 2 seconds until the indicator lights up, and your URC is ready to start searching.
- Aim the URC at your device (e.g. TV), press the “O ” key repeatedly, slowly and patiently until the device has been turned off. Once your device has been turned off, immediately press “ P+” and “ VOL–” to lock in code and the indicator should go out.
Once your device has been turned off, immediately press “
P+” and “ VOL–” to lock in code and the indicator should go out.
- Simply repeat the above setup procedures to search the Device Code for your VCR, SAT, DVD or CTV. (Remember to press a correct Device Mode Key and correct Magic Search Code in step 2-5 above).
