Thursday, April 25, 2013

ERAE ELT3220AP - 32 INCH LCD TV - TEST - ALIGNMENT PROCEDURE - FIRMWARE UPDATE


FUNCTION TEST & ALIGNMENT
ALL MODE RESET
  • Press the “MENU” button and use ◀,▶button to move to “Setup”  menu. Press button to move to “Reset” and press “Enter” to select. Use , button to select “Yes” and press “Enter” button. The PDP TV will turn off then back on in few seconds. The parameters will be set to factory default.
PICTURE SETTING
  • Press the “MENU” button and use ◄/► button to move to “Picture” menu.
  • Press button to move to “Custom adjust” and press “Enter” to select.
  • Use ▲,▼button to the desired category to control and use ◄/►button to adjust the setting.
  • Use ▲,▼ to select between Brightness, Contrast, Color, Tint, Sharpness.
* Test Pattern : Any Pattern or video input with supporting display mode.
SOUND SETTING
  • Press the “MENU” button and use ◄/►button to move to “Sound” menu.
  • Press button to move to “Custom adjust” and press “Enter” to select.
  • Use ▲,▼button to the desired category to control and use ◄/►button to adjust the setting.
  • Use ▲,▼to select between Volume, Balance, Equalizer.
CHANNEL SETTING
  • Press the “MENU” button and use ◄/► button to move to “Channel” menu.
  • Press button to move to “Auto Search” and press “Enter” to select.
  • Use ▲,▼button to move to “Start” and press “Enter “ to start the automatic channel search. All broadcasting channels will be set.
Adjusting PC Screen (Analog RGB)
  • Press the “MENU” button and use ◄/► button to move to “Picture” menu.
  • Press button to move to “PC” and press “Enter” to select.
  • Use ▲,▼ button to the desired category to control and use ◄/► button to adjust the setting.
  • Use ▲,▼ to select between Auto Adjustment, Phase, H-Position, V-Position.
FIRMWARE UPDATE
Equipment Needed
 # RS232 Cable (P/N )   # PC (Personal computer)   # Firmware Upgrade Program.
SETUP PROCEDURE
  • Connect RS232 cable between RS232 connector of LCD TV and COM1 of PC
  • Connect LCD TV Power.
  • Find <FlashExpress.exe> program in the computer.
  • Run < FlashExpress.exe > program.
  • Click where mouse is located and find a directory, which <WARE3.INF> file is in. \
  • And click “OK”
  • Check if the port is COM1 and the protocol speed is 115200.
  • Click “Flash” to upgrade program.