ACCESSING SELF DIAGNOSTIC MENU
- While TV on standby mode, press the following sequence on the Remote commander.
- To Reset Error Count & Error History, Press < 8 > à < 0 > key.
- To Reset Panel Operation Time, Press < 7 > à < 0 > key
- To exit, turn the power off using Remote.
ACCESSING SERVICE MODE
- While TV on standby mode, press the following sequence on the Remote commander.
[< Display> => <5> => <Vol Up> => <Power>]
- Use the ▲/▼ button to select the item you want to refer and press for details.
GAISOU Adjustment (For Board Replacement)
- When new board is replaced, please confirm the color ornamental of the TV set.
- While TV on standby mode, press the following sequence on the Remote commander.
- [<Display> <5> <Vol Up> <Power>]
- Use the▲/▼ button to select the GAISOU item.
- The color variation table of each TV set as below:
- For example if color is Red than it should be, select 03 in the service mode of the TV set.
LED BLINKING
- Standby LED Error Display and Board Replacement Order
- Perform below countermeasures according to Standby LED blinking times.
- When safety shutdown occurs, Standby LED display reports the cause by using the lightning patterns as indicated below.
- The figure above shows LED display when Balancer Error causes SHUTDOWN. It repeats flashing for a specified number of times in 0.5sec/cycle and has a 3 seconds interval of lighting off. Note that a 3 seconds interval of lighting off is fixed regardless of abnormal state types.
Click on images to Enlarge
