APPLICABLE TO MODELS: HL-R5067W _ HL-R4667W _ HL-R5667W _ HL-R6167W [DLP-PROJECTION TELEVISIONS]
TO ENTER SERVICE MODE
- Turn OFF the 'Power' to put the unit into Standby.
- Press [Mute => 1 => 8 => 2 => Power ] buttons on the remote control in sequence.
- Service mode will be displayed on the screen.
- In the case, entry to service mode is unsucessfull, repeat the procedure above.
Service Mode Display
=========================================================
DDP1011(L6)
DNle
ADV7401(M)
ADV7401(S)
Xilleon226
uPD64083
MSP4440
CCA(ON)
Cinema CCA
SP Acuator
ESP
CHECSUM 0000
OPTION
SERVICE
T-HUR2AUS0_XXXX
200X_XX_XX
T-HURUCOM5_XXXX
T-HUR2AUS1_XXXX
==========================================================
Buttons operations within Service Mode.
- Item Selection by moving the Cursor => Use [Up or Dn] keys.
- To increase or decrease the data value to selected item => use [Right or Left] buttons.
- Full Menu display / move to Parent Menu => 'Menu" button.
- Cycles through the active input source that are connected to the unit => Source button.
FACTORY DEFAULT DATA
NO => ITEM => DEFAULT => REMARK
- = V/POSITION / 36 / SCREEN UPPER AND LOWER ADJUSTMENT
- = H/POSITION / 60 / SCREEN LEFT AND RIGHT ADJUSTMENTS.
- = LAMP SYNC / PULSE (P) / PASS (T), PULSE (P0.
- = INDEX RELAY / 40 / SYNCHRONIZES THE BASE POSITION OF THE COLOR WHEEL WITH THE CORRESPONDING COLOR SIGNAL. THIS IS CRITICAL TO NATURAL COLOR DISPLAY. IF THE INDEX DELAY IS NOT PROMPTLY SET, EVEN THE CORRECT 'CCA' COORDINATES WILL NOT HELP WHEN DISPLAYING NATURAL COLORS.
- = SWQ SELECT / 5 / SEQUENCE SELECTION.
- = V-FLIP / NORMAL / VERTICAL FLIP OPERATION.
- = H-FLIP /NORMAL / HORIZONTAL FLIP OPERATION
- = GAMMA / 2 / GAMMA TABLE SELECTION.
- = SLR / OFF / SLR FUNCTION [ON | OFF]
- = DMD_BIAS / E / DMD BIAS PIN VOLTAGE SELECTION.
- = LAMP BOOST / 20 / LAMP BOOST VALUE SELECTION.
- = LAMP SYNC DELAY / 0 / LAMP SYNC DELAY VALUE SELECTION.
- = ENGINE SELECT / SAMSUNG / SAMSUNG AND ZEISS SELECTION.
- = LAMP WATT / 120W / [120W | 135W] SELECTION.
- = LAMP SELECT / PHILIPS / [PHILIPS | OSRAM | USHIO]
- = TEST PATTERN / 0 / THIS DISPLAYS THE BUITLT-IN PATTERN OF THE DDP 1011 CHIP. DDP1011 DRIVES THE DMD PANEL, SO DISPLAYING THIS PATTERN MEANS THAT THERE IS NO ERROR IN THE DDP1011 PROJECTION FUNCTION AND THE PANEL ITSELF.
