SAMSUNG - PL42P7HPX - PLASMA DISPLAY TV _ SERVICE MODE

TO ENTER SERVICE MODE

Using customer remote control

• [Power Off => Mute => 1 => 8 => 2 => Power On].  (Interval between key strokes: less than 3 seconds)
• To "Exit" service mode, Power Off the set, and switch it back On again.

Using Factory Remote control.

• [Power On => Info => Factory key]. Interval between strokes:  less than 3 seconds.
• Press the "Factory" key twice, with a key stroke interval of more than one second {pressing once enters Aging Mode}

Settings when entering Factory Mode

• Sharp Screen (Dynamic), Color tone (Cool-1), Factory (Dynamic CE Off)

Adjustment Procedures

• To select an item, use [Up or Dn] keys, on the remote control.
• To adjust the data value to selected item, use [Left or Right] keys on the remote control.
• Press 'Menu' key to save the settings to the EEPROM and to return the higher-level mode.
• To select channels, use (0 to 9) keys.
• To switch AV modes, use the 'Source' key.

Initial Service mode Display

--------------------------------------------------------------------------------------------------------------

1. Calibration                                                          xxxxx  xxxxx
2. Option table                                                        xxxxx  xxxxx
3. White Balance
4. SVP-FX
5. Option Block
6. STV8258 / STA323W
7. YC Delay
8. Adjust
9. -------
10. W/B Movie
11. Checksum
12. Reset

T-SPRN42NUS-XXXX

T-SPRMNUS-S-XXXX          Boot Merge: OK.

Month / Day / Year

Hour / Minute / second

----------------------------------------------------------------------------------------------------------------

#  The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the improvement of product functions.

# If you have adjusted the settings in Service Mode, have to reset the product.