TO ENTER SERVICE MODE
- Connect a test pattern to the antenna terminal.
- Tune the receiver to this signal.
- Turn the receiver OFF, using the Main Switch.
- Press {Volume Dn & Channel Up} buttons on the Front Panel of the receiver at the same time.
- Keeping these buttons pressed, turn the Mains ON.
- When the set start up, it will be in Service Mode
- Release the two buttons.
- Use the {Channel up | Dn} buttons to move between the options.
- Use {Volume Up | Dn} buttons to change the data value.
- To store the data, use the Standby button on the remote control.
- To "EXIT" service mode, turn the receiver OFF using Mains Switch.
When the Service Mode is entered the following On-Screen display appears:
============================================
SERVICE SOFTWARE VERSION **.**
SW on: XXXX SW off: XXXX Hours ON: XXXX
============================================
The figures displayed in 'XXXX' locations are hexadecimal representations of the number of times that particular function has been executed. For example: if hexadecimal number displayed after "SW ON" was [0E4A], this would correspond to the receiver being turned ON 3658 times.
