To enter service menu by pressing “4” “7” “2” 5”
consecutively while main menu is open.
SOFTWARE UPDATE PROCEDURE
ISP Windows Driver should be installed
- 4 channel cable should be connected to CON5 on ISP apparatus and the other end should be connected to CN117(Next to VGA connector on 17MB30 board. Another option is to use service connector CN108(In front of the tuner). In that case female service connector should be used instead of standard 4 channel cable.
- ISP aparatus should be connected to PC via USB cable
- ISP_Tool_V.X.X.exe is executed
- Click on “Connect” icon located on upper menu tabs
- An information window should pop-up showing: “Device Type is XXXXXX”. Press OK. If the window does not appear check cable connections and close the ISP_Tool_V.X.X.exe. Disconnect USB cable and reconnect. Restart application and repeat the steps all-over again.
- To download a binary to PC “Load” tab is used. To upload a binary file to TV “Read” tab is used.
- Select “Read” Tab from upper menu. Binary file to be uploaded should be specified by clicking “Read” icon.
- Click on “Auto” Tab. Checkboxes to be selected are shown in image below. Before starting to upload the file please make sure these adjustments are made correctly. Then click on “Run” to upload the file. While uploading file please do not interrupt. In case of failed upload retry.
HDCP KEY UPLOAD
- Turn on TV set.
- Open a COM connection using following parameters and select ISP COM Port No
Baud Rate: 9600 bps
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: None
- Enter service menu by pressing “4” “7” “2” 5” consecutively while main menu is open.
- Select “9 Programming”
- Select “HDMI HDCP Update Mode” yes.
- On Hyper Terminal Window press “K”
- Click on send file under Transfer Tab.
- Select Xmodem and choose the HDCP key to be uploaded.
- Press send button
- Restart TV set.
HDMI EDID KEY UPLOAD
- Turn on TV set.
- Connect HDMI cable between TV HDMI port and ISP HDMI port.
- Enter service menu by pressing “4” “7” “2” 5” consecutively while main menu is open.
- Select “9. Programming”
- Select “HDMI DDC Update Mode” ‘YES’.
- Turn off TV set.
- Close all running programs.
- Open MsEEPROM_1.52.exe.
- Make sure EEPROM 24C02 is selected.
- Click ”Load File to Table” as shown in below figure then select the file to be uploaded.
- Select “Write All” from the right hand side menu.
- Compare File to Table and make sure there is no difference.
- Repeat steps for HDMI Port 2.
