- Reverse the projector gently.
- Loosen the screws of the Lamp Lid, and remove the Lid.
- Loosen the lam fixing screws, and remove them.
- Pull up the handle.
- Hold onto projector by the handle as you pull out the lamp.
- Once the lamp has been removed, do not spill liquid on it
- Insert the new lamp securely into the projector body in the right direction.
- Put the handle back to the holding point. Make sure that the handle is locked.
- Tighten the screws.
- Tighten the screws of lamp lid
LAMP TIME RESET
- Plug in the power cord, switch On the projector, and reset the lamp time by pressing [ <, >] and the Power button on the control panel simultaneously.
- If the three buttons are not pressed at the same time, lamp time may not be reset.
- The projector will not turn ON if lamp lid is not secured
- Confirm that the temperature indicator illuminates about 2 seconds and the lamp time has been rest.
- Must reset the the operation time meter after the replacement of lamp.
- Do not reset the operation time meter unless the lamp has been replaced.
