HP - PAVILION - DV 6000 NOTEBOOK PC _ SERVICE HELP _ Contn:

Contn:
                                                                [2]

RTC BATTERY

• Disconnect the RTC battery cable from the system board.
• Remove the RTC battery.
• The RTC battery is secured to the computer by 2-sided tape.  All replacement RTC battery spare part kits Include 2-sided tape.

MINI CARD MODULE

• Make note of which wireless antenna cable is attached to which antenna clip on the Mini Card module before disconnecting the cables, Then disconnect the cables from the module.
• Remove the two Phillips PM2.5×5.0 screws that secure the Mini Card module to the computer. (The edge of the module opposite the socket rises away from the computer).
• Remove the module by pulling it away from the socket at an angle.
• Mini Card modules are designed with a notch to prevent incorrect installation into the Mini Card module socket.

OPTICAL DRIVE

• Remove the Phillips PM2.5×7.0 screw that secures the optical drive to the computer.
• Insert a thin tool, such as a paper clip, into the media tray release hole. (The optical drive media tray releases from the optical drive.)
• Use the media tray frame to slide the optical drive out of the computer.
• Remove the optical drive.

• Position the optical drive with the optical drive bracket toward you.
• Remove the two Phillips PM2.0×3.0 screws that secure the optical drive bracket to the optical drive.
• Remove the optical drive

SWITCH COVER

• Close the computer.
• Turn the computer upside down with the front panel toward you.
• Remove the three Phillips PM2.5×5.0 screws that secure the switch cover to the computer.

• Turn the computer display-side up with the front toward you.
• Open the computer as far as possible.
• Lift the rear edge of the switch cover and swing it forward until it rests on the keyboard.

• Release the zero insertion force (ZIF) connector to which the LED board cable is connected and disconnect the cable from the LED board.
• Remove the switch cover.

KEYBOARD

• Remove the four Phillips PM2.5×7.0 screws that secure the keyboard to the computer.

• Turn the computer display-side up with the front panel toward you.
• Open the computer as far as possible.
• Lift the rear edge of the keyboard until it rests at an angle.
• Slide the keyboard back to disengage the tabs on the front edge of the keyboard from the top cover.
• Swing the keyboard forward until it rests on the palm rest.

• Release the ZIF connector to which the keyboard cable is connected and disconnect the keyboard cable from the system board.
• Remove the keyboard.

SPEAKER ASSEMBLY

• Disconnect the speaker assembly cable from the power button board.
• Remove the two Phillips PM2.5×4.0 screws that secure the speaker assembly to the computer.
• Remove the speaker assembly.

POWER BUTTON BOARD

• Disconnect the microphone cable and the speaker assembly cable from the power button board.
• Release the ZIF connector to which the power button board is connected and disconnect the cable.
• Remove the power button board cable from the clip in the top cover.

• Remove the two Phillips PM2.0×3.0 screws that secure the power button board to the computer.
• Remove the power button board.

Contd: