[Click on images to Enlarge]
- Turn the power off and disconnect the projector from the power outlet. If the lamp is hot, avoid burns by waiting for approximately 45minutes until the lamp has cooled.
- Loosen the screw that secures the lamp cover on the side of the projector until the lamp cover loosens.
- Remove the lamp cover from the projector.
** Do not insert your fingers between the lamp and the projector. The sharp edges inside the projector may cause injuries.
- Loosen the screw that secures the lamp.
- Lift the handle so that it stands up.
- Use the handle to slowly pull the lamp out of the projector.
* Do not place the lamp in locations where water might splash
on it, children can reach it, or near flammable materials.
* Do not insert your hands into the projector after the lamp
is removed. If you touch the optical components inside, it could cause color
unevenness and distortion of the projected images.
- As shown in the figure, lower the new lamp.
- Tighten the screw that secures the lamp.
- Ensure the handle is fully laid flat and locked in place.
- Loose screw may cause a bad connection, which could result in malfunction.
- Do not over tighten the screw.
- Replace the lamp cover on the projector.
- Tighten the screw that secures the lamp cover.
- Loose screw may cause a bad connection, which could result in malfunction.
- Do not over tighten the screw.
RESETTING LAMP TIMER
- Connect the power and restart the projector.
- After the start-up logo, press MENU/EXIT and then press [ < / > ] until the System Setup :
- Advanced menu is highlighted.
- Press [DN] to highlight Lamp Settings and press MODE/ENTER. The Lamp Settings page displays.
- Highlight Reset Lamp Timer and press MODE/ENTER. A warning message displays asking if you want to reset the lamp timer.
- Highlight Reset and press MODE/ENTER. The lamp time will be reset to "0".
INDICATIONS
There are three indicators, which show the
status of the projector. Check the following for information about the
indicator lights. If there is anything wrong, turn the projector off and
contact your dealer.
WHEN PROJECTOR IS IN ABNORMAL STATE
