DISASSEMBLE PROCEDURE
BACK COVER
Remove pointed screws screws on the back cover.
Open the back cover
Remove pointed screws on the back bracket
STAND GUIDE REMOVAL
REMOVAL OF BACK BRACKET
- Remove nut on antenna cable.
- Remove inlet shield cable from SMPS board
- Remove inlet ground cable
- Remove power inlet from back bracket.
- Remove speaker cable connected sub board from back bracket
- Remove back bracket.
CABLES REMOVAL
- Remove Power Control cable from SMPS and LCD Module ( f )
- Remove LVDS cable connected LCD Module and main board LVDS connector unit. ( e )
- Remove Power Cable ( 11 Pin ) connected SMPS and Main Board ( d )
- Remove Power Cable ( 10 Pin ) connected SMPS and Sub Board ( c )
- Remove Inverter Cable 2 connected SMPS and Main Board ( b )
- Remove Inverter Cable 1 connected LVDS board in LCD Module and Module Lamp unit.
POWER SUPPLY & VSC BOARD REMOVAL
- Remove screws on Main Board and Sub Board.
- Remove SMPS Board.
LCD MODULE REMOVAL
- Disassemble Extrusion Bar from LCD Module.
- Remove Board Bracket from LCD Module
- Remove Inner Bracket from LCD Module.
OSD BOARD REMOVAL
- Remove OSD Board from bracket
- Remove OSD Board Bracket and OSD Ground Cable from Extrusion Bar.
- Remove OSD Lens/Knob.
- Remove Aluminum Bracket Frame at 4 corners of Extrusion Bard
- Remove screws
- Remove Frame Fixture at 4 corners.
REPLACEMENT PART LIST {Click on image to ENLARGE]