SELF DIAGNOSIS FUNCTION
The units in this manual contain a self-diagnostic
function. If an error occurs, the STANDBY LED will automatically begin to Flash.
The number of times the LED flashes translates to a probable source of the
problem. A definition of the STANDBY LED flash indicators is listed in the instruction
manual for the user’s knowledge and reference. If an error symptom cannot be
reproduced, the remote commander can be used to review the failure occurrence
data stored in memory to reveal past problems and how often these problems
occur.
When an error occurs, the STANDBY LED will flash
a set number of times to indicate the possible cause of the problem. If there
is more than one error, the LED will
identify the first of the problem areas. Result for all of the following
diagnostic items are displayed on screen. If the screen displays a “0”, no
error has occurred.
Click on images to Enlarge
VIEWING THE SELF CHECK DIAGNOSTIC LIST
For errors with symptoms such as “power sometimes shuts off”
or “screen sometimes goes out” that cannot be confirmed it is possible to bring
up past occurrences of a failure for confirmation on the Self Check diagnostic
screen:
- TV must be in standby mode. (Power off).
- Press the following buttons on the Remote Commander within a second of each other: [(DISPLAY) – (Channel 5) – (Volume -) - (POWER.)]
- NOTE: This differs from accessing Service Adjustments Mode (Volume +)
CLEARING THE SELF CHECK DIAGNOSTIC LIST
Since the diagnostic results displayed on the screen are not
automatically cleared, always check the self-diagnostic screen after you have completed
the repairs to be sure you have cleared the result display to “0”.
- Error history and Error count: [Press the Channel 8 à Channel 0.]
- Panel operation time: [Press the Channel 7 à Channel 0.]
- To exit the Self Diagnostic screen, turn off the power to the TV by pressing the POWER button on the remote or the POWER button on the TV.
There are 2 modes that can be accessed for service. The
Service Mode screen is for informational purposes and the Factory Mode screen,
is similar to 2009.
ACCESSING SERVICE MODE
- TV must be in standby mode. (POWER off).
- Press the following buttons on the Remote Commander within a second of each other:
- To exit service mode, turn the POWER off.
ACCESSING FACTORY MODE
- TV must be turned On. (POWER On)
- Press the following buttons on the Remote Commander within a second of each other.
