LAMP REPLACEMENT
Because
of possibility of injury, strictly follow the replacement procedure below.
- After the cooling fan has stopped, and STANDBY(R) ON(G) indicator turns solid red, unplug the power cord. Note: Wait more than one hour for lamp replacement. [ If you need to replace the lamp more urgently ] The LCD Projector has a forced cooling feature. After the POWER switch is turned OFF, and sometime during about the first minute of the normal cooling fan operation, press MENU for 5 seconds. The cooling fan will change to high speed forabout 10 minutes. (The "C-d" STATUS CODE will be displayed.)
- Loosen 2 screws (A) using a screwdriver as shown in Fig. 3-4-1.
- Remove the Lamp Cover Unit.
- Push the portion (a) of the Lamp Hold Lever to the direction of the arrow as shown in Fig. and release the Lamp Hold Lever from the Fastening Hook.
- Carefully pull the Lamp Unit.
WARNING: The
lamp may be hot. Be careful when handling.
CAUTION: High-pressure
lamp may explode if improperly handled. Danger
of injury due to lamp fragments.
- Install the new Lamp Unit.
Caution: Make
sure that the Lamp Hold Lever is in the original position. Properly
dispose of old Lamp.
- Replace 2 screws (A) using a screwdriver.
- Plug the power code.
Press POWER and INPUT buttons together for about 5 seconds when lighting up red by POWER LED to reset lamp time.
