Wednesday, March 20, 2013

SANYO PLC-XU87 - MULTIMEDIA PROJECTOR - OPTICAL PART DISASSEMBLE PROCEDURE




OPTICAL PART DISASSEMBLY   [Click on images to Enlarge]
  • Before taking this procedure, remove Cabinet Top , Cabinet Front and Main Board following to the “Mechanical Disassembly”.
  • Disassembly requires a 2.0mm hex wrench.

INTEGRATOR LENS-IN DISASSEMBLY
RELAY LENS DISASSEMBLY
POLARIZED GLASS-IN DISASSEMBLY
LCD PANEL / PRISM ASS'Y REMOVAL
IMPORTANT
LCD panels used for this model can not be replaced separately. Do not disassemble the LCD Panel/Prism Ass’y.   These LCD panels are installed with precision at the factory. When replacing the LCD panel, should be replaced whole of the LCD panels and prism ass’y at once.   After replacing LCD Panel/Prism ass’y,  check the following points.
1.  Check that there is no color shading at the top, bottom, left or right of the screen. If there is, try to remove the shading following to the chapter “Optical Adjustment”.
2.  Check the white balance. If it needs the adjustment, adjust the white balance following to the “White Balance Adjustment” , “Gamma Adjustment” and “Common Center Adjustment” in the chapter “Electrical Adjustment”.
3.  Check the white uniformity on the screen.
If you find the color shading at the some part of the screen, it needs to take the color shading adjustment. This adjustment should be performed by a computer and it also requires a special software “Color Shading Correction”.  The software will be supplied separately and can be ordered as follows;
[COLOR SHADING CORRECTION Ver. 4.00;  SERVICE MART NUMBER 645 075 9611]

POLARIZED GLASS, PRE-POLARIZED GLASS REMOVAL
OPTICAL UNIT TOP REMOVAL
OPTICAL PARTS - LOCATIONS AND DIRECTIONS


The arrows in the figure indicate the mount direction of the part for the replacement. Check the number on the arrows and mount each part according to its note;
A: The printed part no. comes to this side.
B: Rugged surface comes to this side.