CONTROLLING SET-TOP BOX
To
control the Set-Top Box (STB) press the
STB button on the remote control. The
STB mode–select button will light for one second to indicate that the
mode has been set. When any valid function button on the remote is pressed, the STB button will light to indicate that a
command is being transmitted in STB mode.
Switching
On or Off
To
turn the STB on or off:
Press
the power button on the Amino remote control. When the STB is switched on the
status light on the front panel is on.
Controlling
a TV
To
control the TV press the TV button on
the remote control. The TV mode–select
button will light
for
one second to indicate that the mode has been set.
When
any valid function button on the remote is pressed, the TV button will light to
indicate that a command is being transmitted in TV mode.
Controlling
the DVD
To
control the DVD press the DVD button on
the remote control. The DVD mode-select
button will light for one second to indicate that the mode has been set.
When any valid function button on the remote is
pressed, the DVD button will light to
indicate that a command is being transmitted in DVD mode.CONFIGURING THE REMOTE CONTROL
In
order for the remote control to transmit the correct signals to control the TV,
the remote control must be programmed with a code corresponding to the brand of
TV in use. Below is a set of instructions for programming TV codes into the
remote:
- Identify the make of the TV; e.g. Sony, Philips etc.
- Find the TV manufacturer in the TV brand code tables in this manual. Most TV manufacturers have more than one brand code listed; if this is the case use the steps below to try all the brand codes until a suitable one is found. If no brand code exists for your manufacturer, try using other popular brand codes.
- Press the TV Mode button and hold for 2.5 seconds. The TV button will blink twice.
- Continue to hold down the TV mode button for another 2.5 seconds. The TV button will blink twice again.
- Release TV mode button.
- Enter the 3-digit TV brand code from the list in this manual. At each key press the mode button will blink. If the TV brand code is accepted, the TV button will flash twice and go out when the 3rd digit is entered.
- If the TV brand code is not accepted, the TV button will remain illuminated for 2.5 seconds and then go out. The remote control will not have been programmed and the process will have to be repeated from the start.
- During the programming steps if no button is pressed for 10 seconds, the TV button light will go out, the remote control will not have been programmed, and the process will have to be repeated from the start.
- The same procedure applies to configuring the remote control in DVD mode.
TV Setup code list: by previous post here
