Procedure to re-install new software of Digital module software for 42PD9700
- RS232C cable should be connected to RS232C terminal of TV set.
- TV set turn ON.
- Press hold [S.MODE], YELLOW and [Blue] button of remote controller until the service menu appears.
- Set data of No 888 from [0] to [1] then press [OK] button.
- RS232C cable should be connected between TV set and PC.
- Program menu appears after double clicking Hyper Terminal Icon.
Bit rate:115200
Data bit:8
Parity: none
Stop bit:1
Flow: none- Click “Transfer” then select ”File send”.
- Select required software file in the folder.
- Turn Off the TV set.
- Click “Send” in the “ File send” menu.
- Turn On the TV set.
- Screen will change and digit of Packet window will start from “0”.
- Should wait until screen has “OK” information.
- Disconnect RS232C cable.
- Press hold [S.MODE], [YELLOW] and [Blue] button of remote controller until the service menu appears
- Data of no.888 should be changed back from [1] to [0] then press [OK] button.
- Turn Off the TV set.
- After, confirmation of a soft version is necessary.
SERIAL(RS-232C) Connector pin specification.
