Monday, April 01, 2013

HP COMPAQ PRESARIO V5000 NOTEBOOK PC - DISPLAY ASSEMBLY DETAILS - COMPONENTS



DISPLAY ASSEMBLY COMPONENTS
  • Remove the six rubber screw covers  [1] and [2] and the six Phillips PM2.5×7.0 screws [3] that secure the display bezel to the display assembly.  The rubber screw covers are available in the Display Screw Kit, spare part number 407795-001
  • The four-rubber screw covers [1] on top edge of the display bezel is a different size and shape than the two rubber screw covers [2] on the bottom edge of the display bezel.
  • The display bezel and display enclosure are available in the Display Plastics Kit, spare part number 407793-001.
  • Flex the inside edges of the left and right sides [1] and the top and bottom sides [2] of the display bezel until the bezel disengages from the display enclosure.
  • Remove the display bezel [3].
  • Disconnect the display panel cable [1] and display backlight cable [2] from the display inverter board.
  • The display hinge base covers are available in the Display Plastics Kit, spare part number 407793-001.
  • If is necessary to replace the display hinge base covers, remove the two Phillips PM2.5×5.0 screws [1] that secure the covers to the display enclosure.
  • Remove the display hinge base covers [2].
  •  Remove the four Phillips PM2.5×5.0 screws [1] that secure the display panel and inverter board to the display enclosure.
  • Remove the display panel [2] and inverter board [3].
The display hinge covers are available in the Display Plastics Kit, spare part number 407793-001.
  • If it is necessary to replace either of the display hinge covers, detach the display hinge cover clips [1] from the display hinge.
  • Swing the display hinge cover [2] back until it clears the display hinge.
  • Slide the hinge cover [3] off of the display hinge.
The display release hook is available in the Display Hinge Kit, spare part number 407797-001.
  • If it is necessary to replace the display release hook, remove the two PM2.5×5.0 screws [1] that secure the hook to the display enclosure.
  • Remove the display release hook [2].
The display hinges are available in the Display Hinge Kit, spare part number 407797-001.
  • If it is necessary to replace the display hinges, remove the four Phillips PM2.0×4.0 screws [1] that secure each hinge to the display panel.
  • Remove the display hinges [2].
The wireless antenna transceivers and cables are available in the Wireless Antenna Kit, spare part number 410118-001.
  • If it is necessary to replace the wireless antenna transceivers and cables, remove the Phillips PM2.5×5.0 screws [1] that secure the wireless antenna transceivers to the display enclosure.
  • Release the retention tabs [2] built in to the display enclosure lining that secure the wireless antenna cables to the display enclosure.
  • Detach the wireless antenna transceivers [3] from the display enclosure.
  • Remove the wireless antenna transceivers and cables [4].
                            For more disassemble procedure, see it here by previous post.