Wednesday, April 03, 2013

VERIZON FIOS - REMOTE CONTROL - SETUP PROCEEDINGS - CODE SEARCH METHOD



PROGRAMMING PROCEDURE

  1. Look up your TV’s brand in the TV code list.
  2. Circle the first 4-digit number displayed for your brand of TV.
  3. Turn on your TV.
  4. Press and hold the TV key.
  5. While holding down the TV key, press the OK key.
  6. Release both keys. The Device Keys will blink twice.
  7. Enter the 4-digit TV code you circled. The TV key will blink three times.
  8. To test to see if this was the correct code, point the remote at your TV and press Power. If the TV turns off, you have successfully programmed your remote.
  9. If the TV does not turn off, repeat all the steps using the next code in the list.
  • For future reference, write down the code that worked, in case you must reprogram your remote.
NOTE: If some of the keys on the remote do not operate your TV as you would expect, then you can try the next code in the list for your brand of TV.
To program the remote to control a VCR or DVD player, press and hold the DVD key, instead of the TV key, in steps 4 and 5. To program an audio receiver, press and hold AUX instead. You can assign a DVD or VCR to the DVD key. The AUX key is reserved for audio receivers, amplifiers and VCRs.
NOTE: The remote will exit the programming mode after 20 seconds if no key is pressed.

CODE SEARCH PROCEDURE
If none of the codes worked, try the following procedure. (As before, we will use the example of a TV. For other devices, use the appropriate Device Key instead of the TV key, in steps 2 and 3.)
  1. Turn on your TV.
  2. Press and hold the TV key.
  3. While holding down the TV key, press the OK key.
  4. Release both keys. The Device Keys will blink twice.
  5. Press (9- 2- 2.)
  6. Point the remote at the TV.
  7. Press  [> ||]
  8. Press [>>]. Every time you press[>>], the remote sends out a new power-off command to the TV. Keep pressing [>>] until the TV turns off. (You can press [<<] to go back.)
When the TV turns off, you have found the right code. Press OK to store this code.

  There are over 200 TV and DVD codes. The most common codes are tried first, but you may still need to press (>>) 200 times to find the right code. If you reach the end of the list of codes, the entire remote will flash twice and return to normal operation. You can exit programming at any time by pressing “Exit”.

                                  For setup code list; visit previous post here:

Posted by at