[ 1 of 4 ] REPAIR PROCEDURE
DRAWER FRONT REMOVAL
- Slide open drawer.
- Locate draw pin on either side of the tub.
- Using a sharp pair of long nose pliers or slip jaw pliers grasp the center dividing web of the pin and pull away from the tub to remove the pin. Support the drawer front with your hand while doing this. Note: The pin web is vertical.
- With both pins removed the bottom of the drawer front can now be eased out slightly.
- Now carefully pull the drawer front down to allow it to come free from the handle and top locating slots.
- Carefully remove the earth wire from the tab on the drawer front. (if it is an integrated model you will also need to unplug the integrated badge from the isolating module)
- Refit in reverse manner ensuring the drawer slides are right forward and the pin secures through the hook on the front end of the slide.
- Note: When reinserting the pins make sure the dividing web is vertical.
TUB REMOVAL
- Open the drawer fully.
- Depress the right-hand tub clip and push it back about 30mm (1 inch). Repeat for the left-hand side.
- The tub may now be lifted up off the drawer runners.
- Slide both runners back into the product.
- Refit in reverse manner.
DRAWER AND LCD DISPLAY REMOVAL
- Remove the drawer front as per instructions given above.
- The handle fits onto a lip at the top of the tub and then slides from left to right to lock into place. Push the right-hand end of the handle to the left until it feels free then remove it out towards you.
- Disconnect the six wire harness from the electronic controller to the LCD interface.
- The handle may now be lifted clear. The LCD display is held in place by a spring tab on one end and a clip in the center. Use a small blade screwdriver to carefully release the tab and center clip as shown. The LCD assembly can now be removed.
- The wiring harness can now be unplugged from the LCD.
- Refit in reverse manner.
DRYING FAN REMOVAL
- Remove the drawer front as per instructions.
- With a small bladed screwdriver carefully release the small plastic clips holding the rinse aid indication LED in place and remove the LED.
- Slide forward the drying fan duct and remove.
- Disconnect the four wire harness from the electronic controller
- Release the three securing tabs that hold the drying fan in place while applying forward pressure on the drying fan.
- The drying fan will now come free.
- Refit in reverse manner.
DETERGENT DISPENSER
- Disconnect the two wiring loom connections off the dispenser coils. Note: Push back locking tabs to allow connectors to release.
- With a small bladed screwdriver carefully release the small plastic clips holding the rinse aid indication LED in place and remove the LED.
- Unclip the fill hose on the dispenser
- While holding the dispenser unscrew the six T10 Torx drive screws securing the brackets around the dispenser.
- The dispenser can now be removed from inside the tub.
- To open up the dispenser door fully, first open the door using the release catch then squeeze the top sides of the door. This will release the door to the fully open position. This can be done with the dispenser in place.
CONTD:
