BACK COVER
- Remove the 12 screws fixing the Back Cover.: RH, +, B, M4, L15, ZPC(BLK), SWRCH18A
- Tap the upper part of the Back Cover 2 or 3 times and pull the Back Cover to separate it from the unit.
- Lift the fixing Chassis up and pull the Back Cabinet to separate it from the unit.
Notice: Disassemble the product after disconnecting the power cord and discharge the unit to prevent an electric shock and damage to the product due to static electricity.
- Remove the power cord fixing the back cover
- Separate the Main chassis from the Front Cabinet.
- Pull the Chassis lifting the fixing clip up.
Notice: Pulling the Chassis by force may
damage the clip or the connector. Pull the Chassis just until the clip comes
off the hole.
- Separate the Speakers, the Side AV Wire, the Front Control from the Feature Box Board.
- Separate the wire from the Wire fixing holder.
- Since there is a clip to connect the Connector Header in the Wire Connector, pulling it by force may damage the clip or the connector. Press the clip down completely and pull the Connector.
- Separate the D-Coil and power cable from the Front Cabinet and Power Board.
- To separate the power cord, slide the fixing clip and lift the cable up.
- Separate the CRT Ass'y from the CRT.
- Separate the TBC wire, GND, VM and Tilt cables from the CRT Ass'y sequentially.
- Separate the cables connecting the FBT and the CRT.
- Notice: Since there may be a remaining high-voltage current within the CRT, take care not to touch the CRT hole with metal or a part of yourself when separating the cables.
- Separate the cables from the Feature Box/Main Board and CRT Ass'y.
- Separate the wires from the FBT of the Deflection Board and the CRT Ass'y.
- To separate the thick red and white wires, pull the wires while pressing the push-type clip at the connector.
- To separate the thin red wire, insert a pin in the small hold next to the hole and pull the wire.
- Notice: Take care when separating the wires because pulling the wires by force may damage the socket. In addition, separate the wires on a flat and clean surface so as to prevent scratching of the material and the PCB.
- Separate the 8 pin cable from the CRT Assy's.
- Separate the 14 pin cable from the Feature Box.
- Separate the cable from the Splitter and the Tuner.
- First separate the cable from the Splitter using a tool such as nippers.
- Since pulling the wire by force may damage the coating of the wire, separate the wire holding the metal part with the tool.
- Remove the DY Connector from the Main Board.
