Contn:
[3]
MEDIUM SUPPORT PANEL
- Remove 4 screws fixing the panel.
- Remove the sub seal connector which is attached to the detergent drawer housing.
- Remove the wire that connected to the valve.
- Remove the valve connection.
- Remove the detergent drawer housing ass'y.
- Remove the wire that connected to the parasitic filter. Remove 2 screws fixing the filter.
- Remove the power cable group as it is shown in the picture.
- Remove the wire that connected to the pressure switch.
- Remove the pressure switch as it is shown in the picture.
- Remove the pressure switch hose handcuffs and pressure switch hose as it is shown in the picture.
- Remove the screw of door lock.
- Remove the wire that connected to the door lock.
- Remove the pipe clip that fixes the drain hose.
- Remove the pipe clip fixing the tub outlet hose.
- Remove the wire that connected to the pump motor.
- Remove the 4 screws fixing the pump motor.
- Remove the wire that connected to the heater.
- Remove the nut fixing the heater.
- Remove 4 screws fixing front counterweight on the front.
- Pull the counterweight back.
- Hold the gasket and gasket body fixing spring together, and pull them up.
- Remove two pins fixing the shock absorber.
- Remove the 2 screws fixing the upper counterweight.
- Remove the 4 screws fixing the spring hanger sheet iron.
- Remove the washing group as it is shown in the picture.
- Remove the insulating belt as it is shown in the picture.
- Insulating belt is used on the washing machines which do not have tub earth cable.
- There is a new label on the belts as seen below, indicating the insulating feature of the component.
- If belt will be ordered for the productions after 01.05.2008, the spare part orders should be done via the related production order part lists.
- Remove the screw fixing the driven pulley.
- Lay down the machine with an angel of 45° to the floor. Disconnect wires and remove the screws fastening the motor under the tub. Pull the motor up for disassembly.
- Remove 17 screws fixing the tub.
END
