DRAIN HOSE, WATER INLET VALVE & CLIP BOX
- To render services to these components, the operators should work on the backside of the machine. The concrete sheet should be removed. The hose holder is taken out by turning as it is seen in the picture.
- The drain hose holder is made up two symmetric parts, which fit together by the help of the snaps, and should be located approximately 30 cm from the hose end.
- For disassembling the water inlet valve, the screw of the water inlet valve located on the concrete sheet is unscrewed.
- Water inlet valve is taken out by being rotated in the clockwise direction. (according to the back of machine).
- For dismantling the interference filter and the main power cable first of all dismantle the sockets.
- Unscrew the screw mounted on the main power cable holder and release the cable.
- Then unscrew the two screws, assembling the interference filter and the concrete sheet.
- Push the filter as it is seen in the picture in order to release it.
FOOTS
- The notch in the middle is pressed by a screwdriver.
UPPER SPRAY ARM
- Upper spray is disassembled from shown snap fit. Upper spray and middle spray feeding hose is a unite part.
END
No comments:
Post a Comment