Sunday, January 13, 2013

SHARP LC-32AD5E405 _ RE-WRITE FOR DIGITAL SOFT FIRMWARE




INSTALL FOR WRITING TOOLS.
  • Set the MICON UPDATE TOOL DISC (JG204) to PC.
  • Install the LPT driver.  NOTE:  It is necessary to install according to the PC.
Windows 95/98 : Setup_LptDrv_v0104_9x.exe
Windows 2000/XP : Setup_LptDrvDev_v020201_XP_2000.exe
Windows NT : Setup_LptDrv_v0104_NT.exe

  • Re-boot the PC.
  • Install the “Setup_Visual_I2C_v3-2-3b8h.exe”, “Setup_VI2C_for_VCT_Pro_v0101.exe” and “Winupload 4.4.3.exe”.
RE-WRITE FOR DIGITAL SOFT FIRMWARE
  • Unplug the AC cord, and remove the back cabinet.
  • Using the Serial Communication Change JIG (JG198) and RS232 Cable, connect the PC terminal and UART Connector(CP2402) on the DIGITAL PCB Ass'y.




  • Connect it in order of Digital Pcb -> Serial Communication Change JIG(JG198) ->  RS232 Cable -> PC.
  • Insert the AC cord, turn on the power.
  • Press both VOLUME DOWN button on the set and Channel button (2) on the remote control for 2 seconds.
  • Confirm that displayed software version.
  • Set the Standby mode.
  • Set the DTV ROM DISC(JG176) to PC.
Start the "Winupload"(Writing tool).
  • Select the "Port Setting" from Process menu, then please set it as follows.  NOTE: This step is not necessary from next time.
  • Select the "Upload" from Process menu, and select the Software(CB00C73221.urt) in DTV ROM DISC(JG176).
  • Select the "Connect" from File menu
  • Unplug the AC cord on the set, then plug it in again.
  • Turn on the power.  The following window will appear, Up-date for Software will start. "Uploading in progress" bar will begin to move

  • When the "Uploading inprogress" bar reaches a right edge, the Writing for Digital Soft Firmware will start.  During the writing for Digital Soft Firmware, writing message will appear on the screen.  Finish the writing for Digital Soft Firmware, writing message will disappear.
  • Unplug the AC cord, and remove the Serial Communication Change JIG(JG198).
  • Insert the AC cord again.



After the write, set to the initializing of shipping.
  1. Turn on the power.
  2. Press both VOLUME DOWN button on the set and Channel button (1) on the remote control for 2 seconds.  The set will turn into the standby mode.

Check for the Firmware Version
  1. Turn on the power.
  2. Press both VOLUME DOWN button on the set and Channel button (2) on the remote control for 2 seconds.  When the changed version displays, the Re-write will be completed.
  3. Select the "Disconnect" from File menu.
 MICON PROGRAM JIG KIT 25-4


Posted by at