- Remove all screws. If you do not remove them, you cannot access the clips.
- Tilt the set a little forward, so that you can release the two click fit clamps that are located at the bottom plate of the set.
- Four openings can be found at the top. The openings are very small. Note: Some sets only have the two inner openings.
- Underneath every opening there is a clip. Push this clip down with a very thin piece of metal, until you hear a click. Caution: do not use a screwdriver, this will damage the cabinet.
- When all four clips are pushed down, the back cover can be removed.
SERVICE POSITION
Before placing the Mono Carrier in its service position, remove the Front Interface assy/panel “Front Interface Assy/Panel”) and the Side AV assy/panel.
- Disconnect the degaussing coil.
- Release the two fixation clamps [1] (at the mid left and mid right side of the bracket), and remove the bracket from the bottom tray, by pulling it backwards.
- Move the panel bracket somewhat to the left and flip it 90 degrees, with the components towards the CRT.
- Turn the panel bracket with the rear I/O toward the CRT.
ASS'Y / PANEL REMOVAL
FRONT INTERFACE ASS'Y/PANEL
- Remove the two fixation screws.
- Remove the complete module from the bottom plate, by pulling the two fixation clamps upward, while sliding the module away from the CRT.
- Release the two fixation clamps at the side of the bracket, and lift the panel out of the bracket (it hinges at one side).
SIDE A/V ASS'Y/PANEL & HDMI INTERFACE PANEL REMOVAL
- Remove the fixation screw, and remove the complete Side AV assembly.
- Release the two fixation clamps, and lift the panel out of the bracket.
- To remove the HDMI Interface panel from the Mono Carrier, unscrew the fixation screw at the back of the assy.
TRIDENT PANEL & TOP CONTROL ASS'Y PANEL REMOVAL
- Remove all cables.
- Pull the panel upwards out of the connectors and remove the Trident panel
- Remove the two fixation screws at the bottom and the two fixation screws at the front of the assy.
- Release the two fixation clamps to lift out the assy.
- Release the two fixation clamps to lift the panel out of the assy.
