SERVICE MODE [FACTORY MODE] ENTRY
- Press “POWER OFF”, then “▲”and “ENTER” at the same time.
- Once more press “POWER ON”and go into the FACTORY MODE
FIRMWARE UPGRADE PROCEDURE
- Prepare N2011E ISP Board in hand first.
- Plug in the ISP Board into your PC Printer Port, then switch the PC on to stand by.
- Install Printer Port Driver, and then install Setup_LptDrv_v020201_XP_2000. After installation is completed, make sure you restart the PC.
- Light up the LCD TV monitor, and then plug the 4Pin female component into the 4Pin male component under the rear cover of the LCD TV. (Note that the LCD TV monitor must be lighted on now)
- Run the .exe file under the path of C:\Program\Micronas\LptDrv\LptDrvTest from your PC. If the following screen appears, then the ISP Printer Port Device is functioning normally.
- Install ISP I2C Driver, and then install the installation program of Setup_Visual_i2c_v3-2-3b8h.exe. After installation is completed, you can see the .exe file under Windows O.S.C::\program\micronas\visual I2C program.
- After the ISP I2C is installed, you can run the C:\VCTI\vct49xyi_start.vi2c.exe program under VCTI menu.
- When the above screen shows, the TVT Item is running, and the following screen will appear.
- When the above picture appears, click on the Bootloader Item with your mouse cursor, and the following screen will appear. Keep running the Bootloader Item until the LCD TV screen disappears all at once, and then you can enter ISP Mode.
- Run Bootloader Version again. Press the Enter key continuously, and the Version 22 screen will appear.
- Run the Erase Flash commander again, and run the Load Bin->Flash commander, and then choose the location of Load Bin File as follows.
- When the following screen appears, the program is being burned in (about 2.5 min), and the program is updated.
