[2]
- To remove kickplate as shown in picture.
- Remove 2 screws fixing the front panel at the bottom.
- Remove 2 screws fixing the door lock.
- Push it down, and remove the front panel.
- Remove 4 screws fixing the panel.
- Remove the sub-seal connector which is attached to the detergent drawer housing.
- Remove the wire that connected to the valve.
- Remove the valve connection.
- Remove the detergent drawer housing ass'y.
- Remove the wire group connected to the parasite filter. Remove two screws fixing the parasite filter.
- Remove the power cable group as shown in picture.
- Remove the wire that is connected the pressure switch.
- Remove the pressure switch as shown in picture.
- Remove the pressure switch hose handcuffs and pressure switch hose as shown in picture.
- Remove the one screw fixing the door cover.
- Remove the wire that connected to the door lock.
- Remove pipe clips that fixes the drain hose.
- Remove pipe clip that fixes the tub outlet hose.
- Remove the wire that connected to the pump motor.
- Remove the four screws fixing the pump motor.
- Remove the wire that connected to the resistance.
- Remove the nut fixing resistor.
- Remove the screws fixing the front counterweight on the front and pull it up.
- Hold the gasket and gasket body fixing spring together and pull them up.
- Remove the two pim fixing the shock absorbar.
- Remove the four screws fixing the spring hanger sheet iron.
- Remove the washing group as shown in picture.
- Remove the 3 screws fixing the upper counterweight.
- Remove the belt shown in figure.
- Remove the screws fixing driven pulley.
- Lay down the machine with an angel of 45° to the floor. Disconnect wires and remove two screws fastening the motor under the tub. Pull the motor up for disassembly.
- Remove 17 screws fixing the tub.
