Tuesday, April 02, 2013

BenQ LCD TV SU-4231 -PAL - SOFTWARE / FIRMWARE UPDATE PROCEDURE - FACTORY MODE/SERVICE MODE



SOFTWARE UPDATE PROCEDURE

Installation software (GProbe 5.0)
  • Install GProbe5.2.0.2.exe
Installation hardware
  • Connect ISP cable (USB to UART board) between PC and LCD TV.
  • The ISP connects located at bottom-rear side.
Install USB(CP2102)driver:
  • Connect ISP cable into computer, the screen of the computer will show install message, please follow up the below steps.
CONFIGURATION SOFTWARE SETTING
  • Finds a director at C:\Program Files\Genesis Microchip\GProbe 5 and put 3 files “isp_16_ext.hex, fli8548_BENQ_board_ext.hex & BENQ_flash16.txt” to there.
  • Turn-on TV. It must set in TV model and Open GProbe5.0
  • Select a proper COM port for connection to GProbe. Follow next figure to check which port is available for use.
  • Turn-on TV power and finish the splash of Logo. Input source don’t at VGA, because if no signal will enter power saving mode and turn-off power.
Update firmware
CHECK UPDATE FIRMWARE
Software content
  • File name: fli8548_BENQ_board_ext.hex, Firmware for Cortez.
  • File name: BENQ_flash16, batch file for ISP.
  • File name: isp_16_ext.hex, driver for ISP.
  • File name: GProbe5.2.0.2.exe
  • Folder name: CP2102_Driver, Driver for adapter of USB to RS232.