Thursday, February 14, 2013

AIWA 25BS1 _ SERVICE MODE - ADJUSTMENT PROCEDURE





SERVICE MODE & ADJUSTMENT PROCEDURE
  • This set has a service mode function that looks like this: 
  • As you can easily repair, reviewed and adjusted.
  • Service mode function does not work when the clock is set.
  • If the clock is set to the state should not set the clock to unplug the AC cord once.
  1. Down volume à 1 à Initialization for shipping.  Caution: Do not use in normal service
  2. Down volume à 6 à Verifying the initial configuration of the memory IC.
  3. Down volume à 8 à Initialization of EEPROM. Caution.:  Do not use in normal service
  4. Down volume à 9 à Adjustment holds the screen.
  • Note: To set the clock to unplug the AC cord.
  • Set the volume to the minimum.
  • Press the key for more than 2 seconds of remote control transmitter at the same time of the channel (6) and the Volume Down key on the main body of the set.
  • To match the address in the up / down volume keys of the remote control transmitter.
  • When you press the key decision of remote control transmitter, the data flash is selected.
  • In the up / down volume key remote control transmitter, decide to fit the data and press the key.
  • Verify that the unit of the data repeat the above
  • Finish checking data after checking the data Power OFF the set.
  • Switch it back ON again.