COMCAST DTA REMOTE CONTROL - CODE SEARCH AND CODE CHECK METHODS

CODE SEARCH METHOD

If your brand of TV does not respond to the remote control after trying all of the codes listed, or if your brand is not listed at all, try searching for your code.

• Turn on your TV.
• Press and hold Setup until the Red Light blinks twice, then release Setup.
• Enter in 9 - 9 - 1. The Red Light will blink twice.
• Press Power and aim the remote control at the TV and press CH + one or more times until the TV turns off.  NOTE: In the search mode, the remote control will send IR codes from its library to the selected device,
• Press Setup once to lock in the code. The Red Light will blink twice.

CHECKING THE CODE

   If you have set up the remote control using the Searching For Your Code procedure, you may need to find out which five-digit code is operating your TV. Perform the following steps after setting up your TV to find out which five-digit code operates your TV.

1. Press and hold Setup until the Red Light blinks twice, then release Setup.
2. Enter in 9 - 9 - 0. The Red Light will blink twice.
3. To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of times the Red Light blinks (e.g., 3 blinks =3) and write down the number in the left most TV Code box (at end of this section).   NOTE: If a code digit is “0”, the red light will not blink.
4. Repeat step 3 four more times for the remaining digits. Use 2 for the second digit, 3 for the third digit, 4 for the fourth digit and 5 for the fifth digit. Finish writing down the code.