SOFTWARE UPDATE
This projector needs computer-aided adjustments.
After the software
adjustments, this projector must be turned off and on again to memorize the
settings.
Connect the connection
interface and communication cable between the projector and a PC.
Updating
the software will change the version number.
- Run software program by the keyboard entry. Note: Use the software program as below. Adjustment Tool [P1SD]
- The first menu is Port selection menu.
- Adjust the projector by selecting the necessary item from the menu in each stage.
Port Selection Menu.
- Select the port name of PC which connects with the projector, then click [Data] or [Adjustment] button.
Explanation
of Buttons
- Data: Displays the data transmission/reception menu.
- Adjustment: Displays the adjustment menu.
- Exit: Exits this application.
DATA TRANSMISSION/RECEPTION MENU
Explanation
of Buttons
- Micom Data Transmission: Reads the microcomputer data from the file and transmits it to the projector.
- Micom Data Reception: Receives the microcomputer data from the projector and writes it in the file.
- Gamma Data Transmission: Reads the gamma data from the file and transmits it to the projector.
- Gamma Data Reception: Receives the gamma data from the projector and writes it in the file.
- Uniformity Data Transmission: Reads the color unevenness correction data from the file and transmits it to the projector.
- Uniformity Data Reception: Receives the color unevenness correction data from the projector and writes it in the file.
- Exit:
Exits this
application.
- Receiving and transmitting of the data. Click a target button and specify a file name.
Adjustment Menu
Explanation
of Buttons
- Input Level Adjustment RGB: Displays the RGB input level adjustment menu.
- Model Info Setup: Displays the model information setup menu.
- Exit: Exits this application.
Flicker
Adjustment: According to the procedure of
chapter 5 "Flicker Adjustment Mode", minimize the flicker.
- Input Level Adjustment: Adjustment Menu
Explanation
of Buttons
- OK: Executes automatic sub contrast and sub brightness adjustments, then closes this dialog.
- Cancel: Cancels this menu.
- PC, RGB Signal Generator, Software for Adjustment
- Display the input level adjustment [RGB] menu.
- Input a window pattern signal to PC IN connector
- Use approx. 15 % window pattern as follows.
- Black background (screen width) : White window width = 2 : 1. Black background (screen height) : White window height = 3 : 1
- Must use the window pattern of S-VGA (800 × 600).
- Click the OK button.
Explanation
of Buttons
- Radio buttons: Selects the corresponding model name.
- OK: Executes model information setup, then closes this dialog.
- Cancel: Cancels this menu.
- PC, Software for Adjustment
- Set the projector into standby mode (POWER button on the projector control panel illuminated red), and execute the following procedure.
- Display the model information setup menu.
- Select the corresponding model name.
- Click the OK button.
