- Copy all files to your computer, Include three files
- ISP_Tool_V43.exe: Debug Tool software for Dynex to update
- Dynex_32HV36_new.bin: New software for Dynex 32 LCD，(Note: Maybe the update filename no as same as Dynex_32hv36_new.bin, the filename only for example) Dynex32_software_update.doc: Document of software update
- Cable Connect: The debug tool board one port connect your computer LPT, the other port connect to Dynex32LCD RS232.
- Connect the Dynex to Power Socket. The Power LED will turn Red. You can update the software at TV Power on of TV Standby.
- Run Debug Tool Software
- Double click the file of ISP_Tool_V43.exe , then you can see the follow picture.
- Click the icon of Device (If not the first time to run this software we can skip this step)
- Set the Device information as below.
Click 'connect' icon.
- If cable connect is ok, you can get the follow picture. If failure please double check the cable connect and try again.
- Click 'Read' icon.
- Click the follow Icon of Read.
- To Select the update software for Dynex.
- Select Open Icon. Then will appear the follow picture.
- Click the Icon of Auto
- Then will appear the follow picture.
- Click the Icon of Run, the software will be updated to Dynex. It will take about 10 minutes.
- If update software is finished and OK, It will appear PASS. If error please retry.
- Disconnect the Dynex from Power Socket, until the Power LED no light, then reconnect the Dynex to Power Socket and Power on the TV.
SERVICE MODE
- Press “INPUT”, “2”, “5”, ”8” and “0” in turn to enter level-one factory menu;
- Press “CH+” and “CH-” to move the cursor to the adjustment page of the level-one factory menu then press “OK” to enter;
- Press “CH+” and “CH-” to move the cursor up and down;
- When the cursor move to a certain adjust item, press “ VOL+” and “VOL –“ to adjust value;
- Press “MENU” to exit to the level-one factory menu;
- Press “EXIT” to exit the factory menu.
- After exit the factory menu, press “SLEEP” to enter the factory menu again as long as power on.
- “Power on mode” item of “Otherseting” menu: on= turn on; off =standby; memory=memory function of turn on.
