SETUP PROCEDURE
- To control the AmiNET530 press the STB button on the remote control. The STB mode–select button will light for one second to indicate that the mode has been set.
- When any valid function button on the remote is pressed, the STB button will light to indicate that a command is being transmitted in STB mode.
- Switching on or off: To turn the AmiNET530 on or off
- Press the power button on the Amino remote control.
- When the AmiNET530 is switched on the status light on the front panel is on.
CONFIGURING THE REMOTE CONTROL
In order for the remote to transmit the correct signals to control
the TV/DVD, the remote must be programmed with a code corresponding to the type
of TV in use. Below is a set of instructions for programming TV codes into the
remote. To program DVD codes into the remote repeat the steps below using the
DVD mode button instead of the TV mode button:
- Identify the make of the TV; e.g. Sony, Philips etc.
- Find the TV make in the TV brand code tables in this manual. Most makes of TV have more than one brand code listed, if this is the case use the steps below to try all the codes until a suitable one is found. If no brand code exists for your make of TV contact your service provider for help.
- Press the TV Mode button and hold for 2.5 seconds. The TV button will blink twice.
- Continue to hold down the TV mode button for another 2.5 seconds. The TV button will blink twice again.
- Release TV mode button.
- Enter the 3-digit TV brand code from the list in this manual. At each key press the mode button will blink. If the TV brand code is accepted, the TV button will flash twice and go out when the 3rd digit is entered.
- If the TV brand code is not accepted, the TV button will remain illuminated for 2.5 seconds and then go out. The remote will not have been programmed and the process will have to be repeated from the start.
- During the programming steps if no is button pressed after 10 seconds, the TV button light will go out, the remote will not have been programmed and the process will have to be repeated from the start.
- If, during programming, the TV button is pressed, the TV button will light for 2.5 seconds and go out.
- The remote will not have been programmed and the process will have to be repeated from the start.
CONTROLLING A TV
- To control the TV press the TV button on the remote control. The TV mode - select button will light for one second to indicate that the mode has been set.
- When any valid function button on the remote is pressed, the TV button will light to indicate that a command is being transmitted in TV mode.
- To control the DVD press the DVD button on the remote control. The DVD mode select button will light for one second to indicate that the mode has been set. When any valid function button on the remote is pressed, the TV button will light to indicate that a command is being transmitted in DVD mode. >> FOR MORE >>
