Monday, February 18, 2013

SAMSUNG WF6450S7W - WASHING MACHINE - DISASSEMBLE PROCEDURE - [1 OF 2]




DISASSEMBLE PROCEDURE              (1 OF 2}

TOOLS NEEDED
No
Tool



1
Box driver
10mm
13mm
19mm
Motor (1), Balance (5), 2 holes of each left and right of the shock absorber 1 Pulley hole

2
Double-ended
spanner
10, 13,19mm
Replaceable for the box driver.  Since the bolt runs idle when the box driver is used, use the
box driver 17mm.

3
Vice pliers

Tool to protect the idle and abrasion of the bolt for the box driver.

4
Other(Driver, Nipper, Long nose)

General tools for the after service.
5
JIG for the Tub

1 (Disassemble and Assemble)
TOP COVER ASS'Y
  • Remove the two screws holding the Top Cover at the back of the unit.
  • Remove the top-cover through pushing and pulling.
  • Then, the Water (Pressure) Sensor, Noise Filter and Water Valve can be replaced.
  • Remove the Top Cover and the Ass’y Drawer.
  • Remove the two screws on the front of the control panel.
  • Remove the one screw on the plate(U).
  • Remove the control panel by disconnecting the connector that connects PCB to the wire-harness.
  • Insert a flat head screwdriver into the gap and pry down the Cover Front (Left) to separate it.
  • Remove the Wire Diaphragm from the Frame Front and unseat the Diaphragm.
  • Remove the 7 screws on the frame front.
  • Before removing the belt, should be opened the Cover Bottom.
  • Remove the belt before the re-assembly.
  • Ensure the belt is placed on the center of the motor pulley.
[Belt Assembly]

  • Hang the belt on the motor pulley before placing it around the pulley.

Contd: