Monday, February 18, 2013

SAMSUNG WF6450S7W - WASHING MACHINE - DISASSEMBLE PROCEDURE -[2 OF 2]



MOTOR
  • Remove the wire housing from the motor.
  • Remove the bolts holding the motor by using the power screwdriver.
  • Remove the motor.
WATER SUPPLY VALVE
  • Remove the fixing screws for the water supply valve.
  • Disconnect the valve wires.
  • Separate the water hoses
WATER LEVEL SENSOR
  • Remove the top cover.
  • Remove the fi xing screws for the water level sensor.
  • Disconnect the water level sensor harness.
  • Disconnect the hose pressure.
  • Replace the water level sensor.

DOOR HINGE
  • Remove the fi xing screws holding the Door-Glass.
  • Separate the glass.
  • After removing the two screws holding the Holder Glass, replace the Door Hinge.
  • After putting them back together, check if the screws holding the Door Hinge is fastened properly.

DRAIN PUMP
  • Insert the fl at head screwdriver into the slot on the top of the Cover Filter and lever it down to separate it.
  • Unscrew the drain filter by turning it counter clockwise.
  • The water remaining inside could flow out. So, put an empty bowl on the floor to hold the water.

  • Tilt the unit backward and take out the drain pump.
  • Disconnect the incoming water hose and the wire harness.  (Caution: Check if the unit is plugged out. There is possibility of electric shock.)

  • Separate the Hose Filter Tub and the Drain Hose.
CHECK POINT
  1.  Remove the Drain Filter and check if there are foreign substances (coin, buttons, etc) blocking inside - If so, clear the inside.
  2. Check if the wire harness is connected properly - If not, connect it properly.
  3. If water leaks, check if the Clamp Hose and the Cap Drain are assembled tightly.   If not, assemble them tightly.
  4. Remove the water remaining inside by turning the Filter counter clockwise.
DOOR S/W
  • Open the door.
  • Remove the Spring Diaphragm and separate the Diaphragm from the Frame Front.
  • Insert the flat head screwdriver and pry up the spring to remove the Spring Diaphragm.
  • The Diaphragm could get damaged when taking it out. So, unseat it in one direction slowly.


Remove the screws holding the Door S/W.
Take out the Door S/W.
 Disconnect the wire connector. (Press the hook to unlock the tab and plug it out.)
Remove the frame-front.


  • Disconnect the connector housing.
  • Remove the nut holding the heater, and separate the heater.
  • Take out the heater from the tub.  Be sure to insert the heater into the bracket in the tub.  If not, it may cause a fire.  Make sure to have a packing seating on its place.  Fasten the nut with 5Kgmf/cm2.  If the nut is fastened loosely it may cause water damage.