TO ENTER SERVICE MODE
This
model's setting are adjusted in two different ways: through the I2C bus control
and in the conventional analog manner. The adjustments via the I2C bus control
include preset only items and variable data.
- Press and hold the local key "VOL DOWN" & "CH UP" when power on the main switch,TV will enter into the SERVICE MODE. (The initial values of EEPROM are automatically preset when new EEPROM is used.
- Press the CH DOWN / UP key on the remote controller to get ready to select the mode one by one.
- Press the CH DOWN / UP key on the remote controller to select the modes reversibly one by one.
- Using the VOLUME UP/ DOWN key on the remote controller, the data can be modified.
- Use the MENU Key on the remote controller to select the mode as shown in the next page.
- When press the local key "VOL DOWN" & "CH UP" at the same time, it will be released from the service mode.
FACTORY PRESETTING
- After enter into the SERVICE MODE, at "INIT EEPROM" SERVICE ITEM (which is under "CHECK MODE" section) press REMOTE CONTROLLER key of code "ED" the initial values are automatically preset.
- Make sure whether the data need to modify or not (Initial data).
Note: Once the chassis has been
assembly together and in ready condition, please make sure it's go through
initialize process.
Precaution: If
haven't done this initialization, malfunction might be happen.
