B+ VOLTAGE ADJUSTMENT
- Adjust the voltage of the pin (4) of P1900 to 5.00 ±0.02V with R3714.
- Note: Since 5.0V is a reference voltage of all power voltage, adjust it precisely.
COUNTER - BIAS ADJUSTMENT
- Vary the "COM BIAS" setting on Page 2 of the adjustment process mode so that the contrast be sharpest (black looks most sinking).
TAMP ADJUSTMENT
- Receive the upper left of 75% white half color bar signal.
- Make the "PAL TAMP" adjustment to get the "Y" reading in the range of AE thru BD.
- If the adjustment of "PAL TAMP" is executed, write its adjustment value to the "SECAM TAMP" manually.
WHITE BALANCE ADJUSTMENT
- Adjust "RCUTOFF", "BCUTOFF", "RGAIN" and "BGAIN" on the page 2 of the adjustment processing so as to obtain the color of the same level as the standard set.
FACTORY SETTINGS
Perform a factory setting after
completing all adjustments.
- A "POWER" keys is made on with pushing an "TV/VIDEO" and "MENU" keys at the same time.
- "K" of the inspection process mode is displayed on the screen upper left.
- CH (รน) and VOL (+) keys are pushed about 2 seconds at the same time.
- Release keys, if "E" is displayed on the screen upper left and "COMPLETE" is displayed on the bottom of it.
- After a while, a power will be in a standby mode and a setup will be finished.
- Note: "First installation" serves on "Deutsch".
LAMP ERROR DETECTION
This LCD color television has a
function (lamp error detection) to be turned OFF automatically for safety when
the lamp or lamp circuit is abnormal.
If the lamp or lamp circuit is
abnormal, or some other errors happen, and the lamp error detection is executed,
the followings occur.
- The main unit of television is turned OFF 5 seconds after it is turned ON. (The power LED on the front side of TV turns from green to red.)
- If the situation 1 happens 5 times sequentially, television can not be turned ON. (The power LED remains red.)
Countermeasures
Check when turning OFF the lamp error
detection
When television is turned OFF by the
lamp error detection mentioned above, it enters the adjustment process with the
power LED red. Entering the adjustment process turns OFF the error detection
and turns ON TV.
This enables the operation check to
detect errors in the lamp or lamp circuit.
Check whether "ERROR NO
RESET" on line 3, page 1 of the adjustment process is 1 or more. If it is
1 or more, it indicates the lamp error detection was executed.
RESETTING OF LAMP ERROR COUNT
- After confirming that the lamp or lamp circuit is normal, reset the lamp error count. Select "ERROR NO RESET" on line 3, page 1 of the adjustment process and set the number to 0 using the volume button.
NOTE: 13=LC-13S1E,
15=LC-15S1E
Afterwards, perform the operation
check to confirm that the lamp error detection does not function.
