Before update the VCTP software, it is necessary to install the WRITING TOOLS into the PC.
- Unplug the AC cord and remove back cabinet.
- Short circuit 1 pin and 2 pin of CP802 on the main PCB.
- Insert AC cord.
- Remove the short circuit 1 pin and 2 pin of CP802 on the main PCB.
- Set EU LCD MICON VER UP ROM DISC (JG176) to PC.
- Start the 'VCTP' [Writing Tools].
- Select the 'LPT Preferences' from File/Preferences Menu, the input '5' to the value of delay, and press OK.
- Using the MICON PROGRAM JIG KIT 25-4 (JG203), connect the PC Terminal and 1 ~ 4 pin of CP802 on the main PCB {JG203 (Red Line) = 1 pin of CP802}
- Press the 'TVT'
- Remove the check of "Bootloader Version", and check it again. NOTE: When the number of the side of the check box becomes 40, can proceed to next step. If the number doesn't become 40, check the connection and try again from step-1
- Press the 'Erase Flash". then press the "Load Bin -> Flash" twice.
- Press | ---|, and select the writing firmware.
- Select the "Address", then input the "0x7ffff", and press the OK.
- Press "Load Bin -> Flash". The following window will appear, then writing will start. After the finishing of writing, window will close.
- Finish the writing, unplug the AC cord, and remove the MICON PROGRAM JING KIT 25-4.
- Insert AC cord again. Turn On Power.
- Press Both "Volume Down" button on the TV set, and "Channel-2" button on the remote control for 2 seconds.
- Confirm that the displayed version agreement with writing.
No comments:
Post a Comment