CPLD DOWNLOAD
- Connect the PC and memory JIG.
- Turn on JIG MAIN POWER SW.
- Turn on the PC and monitor, operate the ‘Device Programming’ software.
- Once the program is running, [OPTION MODE SELECTION] is displayed in the window.
- Check the “Load configuration File(.cdf, .pdr)” in this window and click the ‘finish’ button
- When the screen displays the “open” window, select the suitable file(*.cdf) according to model.
- IC figure is change to green by clicking it.
- Select program options.
- Check the [Erase before programming] and [Verify] menu.
At this time, the download
starts. The download will finish in about 10 seconds.
EDID DATA INPUT
TOOLS
- PC, Jig for adjusting DDC. (256 bytes write)
- S/W for writing DDC(EDID data write & read)
- Cable for HDMI EDID Download
- Set devices as above and turn on the PC and JIG.
- Open S/W for writing DDC (EDID data write & read).
- Enter the Model --> Open in the Menu and then select EDID DATA.
- Click the Digital and cancel the ANALOG.
- Then connect to turn on the yellow light at the board & connection.
- Click the Write Data & Verify and then download the EDID DATA
MICOM DOWNLOAD
- Connect the PC Parallel Port to download JIG, and connect the download JIG to P1700 of Board.
- Set PC program for JIG download as shown below. then operate the download.
IN CASE OF Win ISP 3.0
- CONFIGURE THE PROGRAM FOR DOWNLOAD.
- MCU Select : MTV412M128(Use to MTV416)
- R/W Option Auto Write(Verify)
- Jig Option Myson
- Transmit Speed : Medium
- Check : blank
- PORT “ Using Parallel Port(LPT1). * LPT must be selected to EPP at Rom BIAS.
- Select the Save Setting.
Click the “Send” button after
selecting the Load File and Loading the Hex File.
