Tuesday, December 25, 2012

PANASONIC - TX-32LX60F / TX-32LX60P / TX-26LX60F / TX-26LX60P _ LCD TV _ SERVICE MODE _ WHITE BALANCE ADJUSTMENT




TO ENTER SERVICE MODE

  • Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the remote control and press the down button (-/v) on the TV set, this will place the TV set into the Service Mode 1.
KEY COMMANDS IN SERVICE MODE
  • Press the RED / GREEN buttons to step up / down through the functions.
  • Press the YELLOW / BLUE buttons to alter the function values, to alter White Rasters use +/- buttons
  • Press the OK button after each adjustment has been made to store the required values.
  • To exit the Service Mode, press the "N" button.
WHITE BALANCE ADJUSTMENT
  • Switch on the TV Set. Enter Service1.
  • Step down to Highlight line and keep the aging time more than 20 minutes.
  • After aging time above set White Raster No.12 for Highlight and No.4 for Lowlight Press the OK button to store.
  • Put Minolta Sensor to the center of the LCD Panel with 25mm gap between Minolta Sensor and LCD Panel. Adjust "x" and "y" values by changing Red and Blue values.
  • Press OK button to store setting.
SELF CHECK FUNCTION
  • Self-check is used to automatically check the bus lines and hexadecimal code of the TV set. To enter Self-Check mode, keep pressing the STATUS button on the remote control and press the down (-/v) button on the TV set.
  • To exit Self Check, switch off the TV set at the power button.